Blanket panel #1 complete

Sooooo… it’s actually going to be four horizontal panels instead of three vertical ones.  This is because when I was doing my warp math I put down 60″ instead of 72″ for the blanket length.  *headdesk*  So the panels are going to be 4.5 feet wide; with shrinkage it’ll be just over four feet, which is perfect for the width.  Yay for a happy coincidence that I don’t have to throw out this entire panel and start over…

When I finished the weaving I put on the scrap yarn:


And then I’ll take it off the loom and warp the second panel later today.  Can’t wait!

Leave a Reply

Your email address will not be published. Required fields are marked *